System Components - Maico PP 45 O Bedienungsanleitung

1 System components

The following ventilation units and room air
controls can be combined in a PP 45/PPB 30
system and can have various sensors added.
For possible combinations Commissioning
instructions.
Ventilation units/slide-in modules
PP 45 O
Object unit
PP 45 K Comfort unit
PP 45 RC Radio-controlled unit
PPB 30 O
Object unit
PPB 30 K Comfort unit
Room air controls
Object room air control
RLS 45 O
(for PP 45 O/K)
Comfort room air control
RLS 45 K
(for PP 45 O/K or PPB 30 O/K)
DS 45 RC Radio switch for PP 45 RC
(not permitted for PPB 30)
PP 45
ventilation units/slide-in modules
1 Front cover for internal housing
2 Shutter for PP 45 K/RC housing
3 Internal housing for PP 45 K/RC
3.1 Internal housing for PP 45 O
4 PP 45 O: rotary knob for shutter
5 Pull-out belt
6 Filter seat
7 G2 air filter (inside)
8 Complete fan unit, with connection
cable
9 Profile seal
10 Slide-in sleeve
11 Ceramic heat exchanger
12 G3 air filter (outside)
13 External cover / soffit element
14 Humidity sensor for PP 45 HYI, optional
(with PP 45 RC only for master unit)
1 System components | UK
15 PP 45 K/RC: servomotor for shutter
16 PP 45 RC: LEARN key
17 PP 45 RC: status LEDs orange/blue/red
18 PP 45 RC: SET key
19 Motor connection plug
PPB 30
ventilation units/slide-in modules
14 PP 45 HYI humidity sensor (optional)
Fan unit [20] - [23]
20 Slide-in sleeve, incl. 2 fans
and diffusers
21 Ceramic heat exchanger
22 Profile seal
23 Fluid distributor slide-in module
24 Internal cover with sealing mat [25]
26 Electronics cover
27 PPB 30 K electronic circuit board
27.1 Fan1/Fan2 connector bush
27.2 DIP switch for unit addressing
(0 = unit 1 / 1 = unit 2 / 2 = unit 3)
27.3 Connection terminal, 4-pin (RLS 45 K)
27.4 Connection terminal, 2-pin (button/switch
for exhaust air operation/intermittent
ventilation)
27.5 Humidity sensor
28 PPB 30 O electronic circuit board
28.1 Fan1/Fan2 connector bush
28.2 Connection terminal, 4-pin
(12 V control cable RLS 45 O/K)
29 Internal housing
30 G3 air filter
31 Cable grommet
32 Fluid distributor internal cover
33 Centring ring
34 Extension (standard 200 mm,
optional 500 mm) with gasket
on inside and out
35 External housing (PP 30 AK/AE/AW) with
integrated fluid distributor
36 External cover (PP 30 AK/AE/AW)
33