Tt 2 Adjustment - Clearaudio TT2 Bedienungsanleitung

To tighten the headshell, please move the carriage to the right side of the tonearm.
Lock the headshell in the carriage from above through the small hole in the top of the cover
plate by using the hex key wrench (#1.5) (Pic. 11).
Pic.11: Locking the headshell (backside of the tonearm)

4. TT 2 adjustment

4.1 Adjustment of the cartridge
The now following adjustment requires an already mounted cartridge on the headshell.
Therefore please follow the instructions in the users' manual of the cartridge manufacture.
Please do not remove the needle protection of the cartridge!
Attention:
This tonearm is suitable for cartridges from 7 gr. net weight!
If your cartridge is easier, please use an additional weight (headshell plate).
Connect the pins of the tonearm cable with the corresponding pins of the cartridge.
Please take care of the colour codes.
Red: right channel / R+
Green: right channel / R-
White: left channel / L+
Blue: left channel / L-
Adjust little stylus pressure. The exact stylus pressure will be adjusted later.
Seite / Page 8
TT 2
User manual / Bedienungsanleitung
 clearaudio electronic GmbH 2014