Clearaudio TT2 Bedienungsanleitung Seite 9

TT 2
User manual / Bedienungsanleitung
Therefore take one or more counterweight(s) (depending on the weight of your cartridge)
and slide them onto the headshell as shown in picture 12. Adjust little stylus pressure, while
sliding the counterweight(s) in the direction of the cartridge.
Pic.12: Set up of counterweight(s)
Now lock the counterweight(s) by using the hex key wrench # 1.5.
It is easier, if the tonearm is in vertical position (as shown in picture 13).
Pic.13: Locking the counterweight(s)
4.2 VTA - adjustment
The following adjustment can be done with an old and used
record. This LP should be flat.
Instead of a record you can also use the delivered linear tracking
gauge.
To achieve the right height of the cartridge you can move the
tonearm by turning the VTA screw on the top of the tonearm
(shown in picture 14).
Pic.14: Height adjustment
Seite / Page 9  clearaudio electronic GmbH 2014