Adjustment Of The Azimuth (Vertical Needle-Position In The Groove) - Clearaudio TT2 Bedienungsanleitung

TT 2
User manual / Bedienungsanleitung
The carbon headshell tube should be parallel to the surface of the record (without needle
protection and cartridge lifted down record!).
The tonearm angle can be adjusted with the screw in the tonearm
base (see pic. 15 b).
The tonearm angle is correct adjusted, if the bubble level is centered.
Pic.15 a: Bubble level
Pic.15 b: Adjustment of the tonearm`s tilt angle
Adjust the correct stylus pressure as instructed in the cartridge´s user manual.
To achieve the exact stylus pressure we recommend the use of the clearaudio digital stylus
pressure gauge "Weight Watcher" (Art.-#: AC 094; also available at www.analogshop.de).

4.3 Adjustment of the Azimuth (vertical needle-position in the groove)

Please be very careful by the following steps:
Lift your cartridge up (!)
Take a straight bar or rod (e.g. hex key wrench) which can be placed on the top of the
cartridge.
Place this piece on top of the headshell as shown in the picture 16 and secure it with an
piece of adhesive tape.
a b
a = b !
Pic.16: Adjustment of the Azimuth
Seite / Page 10  clearaudio electronic GmbH 2014