Clearaudio TT2 Bedienungsanleitung Seite 7

Tighten the screw of the tonearm base as shown in
picture 6.
Before the next step please first remove all
counterweights from the headshell.
Slide the headshell through the proper drilling in the
carriage of the tonearm.
When sliding the headshell, turn the headshell
(as shown in pic. 8) so that the positioning shaft of the
headshell can pass the main rod of the tonearm.
After passing the first main rod, turn the headshell back
(as shown in pic. 9)
Pic.8: Turning the headshell
Approx.
1.5 cm
(15 mm) /
0.59 inch
Seite / Page 7
Positioning shaft
Pic.10: Correct position of the headshell
TT 2
User manual / Bedienungsanleitung
Pic.6: Tighten the screw of the VTA-assembly
Pic.8: To seize the screw
Pic.7: Setting up the headshell
Pic.9: Turning the headshell back
 clearaudio electronic GmbH 2014
Distance between
diamond tip and
headshell locking
screw
is approx.
62 mm / 2.44 inch