Azimuth Adjustment - Clearaudio Emotion SE Bedienungsanleitung

User manual / Bedienungsanleitung
4.)
For the next settings, place any LP on the platter and remove the stylus protector.
If you now lift down the cartridge to the middle of the turntable platter, you must see (from the
side) that the lower edge of the tonearm tube is parallel to the surface of the record. You can use
the tonearm tube as orientation.
Pic. 9: Setting the VTA
If it is necessary you can adjust the height of the tonearm (VTA). For that you have to move the
tonearm in the chassis's hole in the right direction (up an down). Fix the tonearm in its correct
position by locking the allen screw in the tonearm base.

5.) Azimuth adjustment

If you now lift down the cartridge again and take a look at the front side of the cartridge. You have
to make sure that the upper edge of the cartridge is parallel to the record surface. This adjustment
had been set up perfectly by Clearaudio. Only if it is necessary, you can adjust the cartridge posi-
tion, while carefully screw the small allen screw on the bottom side of the tonearm tube near the
(Caution: please don't unscrew the allen screw
headshell
the headshell with the mounted cartridge around his roll-axis. To achieve the most precise adjust-
ment you can use a set square.
If you have found the right position you can carefully lock the small allen screw without changing the
position defined before.
!
Don't twist the headshell when the cartridge is lifted down and the diamond tip
is on the record. It is necessary to lift the tip from the record, before you can
check the position again.
6.)
For the final setup of the tonearm, you need the cartridge alignment gauge which is included as
Pic. 10: Alignment of the cartridge
Made in Germany
well.
Slide the gauge over the spindle of the turntable platter and
turn the platter into the position as shown in the picture 9.
Tonearm parallel
to platter
completely). Now you can twist
11