Tonearm Base / Tonearm Adjustment - Clearaudio Champion Magnum Bedienungsanleitung

6. Place the belt first round the platter, then round the smaller diameter of the pulley (33 1/3 rpm).
7. The tension of the belt can be changed by turning the motor
about its axis. The tension is correct if the correct turntable
speed is achieved within 10 seconds. If the tension is too
high, the motor could start to vibrate a little bit. If the
tension is too loose, the turntable will not achieve a constant
and correct speed.
8. Please mount the cartridge as instructed by the manufacturer!
9. If you should have problems with hum, the turntable may
need to be grounded. In this case, connect the grounding
wire supplied to the screw of the bearing and to the earth
connector of your amplifier.
Champion
The clearaudio
4. Tonearmbase
The clearaudio Champion Magnum turntable is regularly
delivered with preassembled Unify-Tonearm base. If
requested the clearaudio Champion Magnum turntable had
been delivered with another tonearm base that you have
chosen before. In this case please follow the instructions of
the manufacturer for the tonearm adjustments.
Seite/Page 15
Magnum turntable is now completely assembled and you can now enjoy
listening to music.
Champion
 clearaudio electronic GmbH 2006
Magnum
Bedienungsanleitung
USER MANUAL