Technical Data - EINHELL PS-PS 750 Laser Bedienungsanleitung

Anleitung PS-PS 750 Laser_SPK1
2.6 Use of the batteries
Ensure that the ON/OFF switch for the laser is
set to its OFF position before you fit the bat-
teries.
Inserting the batteries when the laser is switched
on can cause accidents.
If the tool is not used correctly the batteries
may leak. Avoid contact with the battery fluid.
If you come into contact with battery fluid,
clean the affected body part with running
water. If you get battery fluid in your eyes,
seek immediate medical assistance.
Leaked battery fluid can cause skin irritation and
acid burns.
3. CONTROL ELEMENTS (Fig. 1 / 2)
Check that all the parts are present.
1. Speed controller
2. Locking button
3. ON/OFF switch
4. Handle
5. Switch for pendulum action settings
6. (Saw blade) safety hood
7. Guide roller
8. Parallel stop
9. Saw blade
10. Vacuum cleaner port
11. Lever to adjust the cutting angle
12. Saw blade holder
13. Safety frame
14. Securing screw
15. Saw foot
16. Mains cable with mains plug
17. Battery compartment cover
18. ON/OFF switch for laser
19. Laser

4. TECHNICAL DATA

Power input:
Rated voltage:
Rated frequency:
Idle speed n 0 : 500-3000 rpm
Maximum cutting depths
Wood:
Plastic:
Steel:
Cutting angle: 0-45° (left/right)
Weight (excluding accessories):
Protection class:
23.08.2005 10:23 Uhr
Noise and vibration
Permanent noise level:
Peak noise level:
Hand-arm vibration:
Marking laser:
(See also section entitled "Laser safety instructions")
Power supply: 3 V (2 x 1.5 V button cell)
Laser class:
Laser light: 650 nm, max. < 1mW
Important! Laser class 2 – laser radiation, do
not look into the beam.
5. PREPARATION
5.1 Saw blade (Fig. 3)
You can fit or replace saw blades without using
any other tools.
Pull the mains plug before you fit/replace a saw
blade.
Set the switch for pendulum action settings to
position 3.
The teeth of the saw blade are very sharp!
Place the jigsaw upside down on a table: Position
the handles on the top of the table and have the
saw foot facing upwards.
5.1.1 Fitting the saw blade
Turn the saw blade holder (12) counter-clockwise as
far as it will go. Fit the saw blade (9) into the groove
in the saw blade holder until you feel that it will not go
any further. Direct the saw teeth towards the front. To
ensure that the saw blade can be controlled easily
750 W
the roller (7) must be in contact with the blade.
230 V~
Release the saw blade holder (12); the holder will
50 Hz return to its previous position and will thus secure the
saw blade. Now ensure that the saw blade is secure-
ly engaged by pressing the saw blade slightly
towards the saw blade holder.
80 mm
20 mm
5.1.2 Removing the saw blade
12 mm
Turn the saw blade holder (12) counter-clockwise as
far as it will go. The saw blade (9) will be released
1,6 kg and will jump forwards slightly. Take the saw blade
out of the groove and release the saw blade holder.
II / ®
Seite 15
GB
88,8 dB(A)
101,8 dB(A)
12,3 m/s2
Line laser
2
15