Reely Bad Boy Bedienungsanleitung Seite 51

Setting Rear Axle Camber:
For setting the camber, twist the screw (1) of the upper
transverse link as for the front axle.
A suitable open-faced spanner can be used for turning (not
enclosed).
Because this screw has a left and right hand thread at
either end, the transverse link does not need to be dis-
mantled for the camber to be adjusted.
At the rear damper bridge (2) and in the axle spur (3) there are several different suspension points for the
upper transverse link. If the transverse link was attached in a different location, this would change the cam-
ber when the wheel deflects and extends.
The manufacturer has already selected the best setting for the vehicle. Therefore, no changes should be
made.
Note:
• Change the settings only gradually and then check the changed running conduct to see if it corresponds
to your expectations. Write down the changes made so that you can easily reverse them again.
• Twist the screws of the two transverse links at the front axle and the rear axle evenly at all times, since
different settings at the left/right wheel will cause unforeseeable driving behaviour.
1
2
3
51