Herunterladen Inhalt Inhalt Diese Seite drucken

Reely Bad Boy Bedienungsanleitung Seite 37

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

• Don't drive towards animals or people!
• Avoid driving at very low outdoor temperatures. Plastic parts lose elasticity, which may lead to damage even in a
light accident.
• Do not drive in thunderstorms; don't drive under high-voltage power lines or in the proximity of radio masts.
• Don't drive in the rain, through wet grass, water, mud or snow. The model is not waterproof or watertight.
Moisture not only causes corrosion but also damages the electronics. In a LiPo battery, entering moisture
may set the battery on fire or even cause an explosion!
• As long as the vehicle is in operation you must always leave the transmitter switched on.
• When parking the vehicle, always switch off the vehicle's speed controller first and disconnect the drive battery from
the speed controller completely then.
Now you may turn off the transmitter.
• If the batteries (or rechargeable batteries) in the transmitter are weak, their range decreases. Exchange the batte-
ries or rechargeable batteries for new ones.
When the car's two drive batteries are weak, the car gets slower or no longer responds correctly to the transmitter.
The drive batteries in the vehicle are not only used for supplying the engine via the speed controller. The
speed controller also generates the voltage/current required for operating the receiver and the steering
servo.
For this, the speed controller has an integrated BEC („Battery Eliminator Circuit"; electronic circuit for direct
voltage supply of the receiver without additional receiver battery).
If the voltage in the drive batteries is too low, the voltage at the receiver may also drop, causing the vehicle
to no longer respond to the control commands at the transmitter.
In this case, stop driving at once (switch off speed controller, disconnect drive batteries from vehicle, switch off
transmitter). Then replace the two drive batteries of the vehicle or recharge the drive batteries.
• The motor and drive as well as speed controller and drive batteries of the vehicle get hot during operation. Wait at
least 5 to 10 minutes before exchanging the rechargeable battery.
Let the drive batteries cool down completely before charging it.
Do not touch the motor, the speed controller or the rechargeable drive batteries until they have cooled down. Danger
of burns!
• If you operate the vehicle with two LiPo drive batteries, the undervoltage recognition in the speed controller must be
activated (we recommend 3.0 V/cell or higher).
With the undervoltage recognition deactivated, the LiPo batteries will suffer deep discharge and be destro-
yed. Loss of guarantee/warranty!
At operation with NiMH drive batteries, the undervoltage recognition should be switched off to better use the capa-
city of the NiMH batteries. Terminate operation here if the vehicle slows down.
37

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis