Troubleshooting - Scheppach DECO-XL Originalbetriebsanweisung

Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
can occur, for example, by handing it in at an author-
ised collecting point for the recycling of waste elec-
trical and electronic equipment. Improper handling
of waste equipment may have negative consequenc-
es for the environment and human health due to po-
tentially hazardous substances that are often con-
tained in electrical and electronic equipment. By
properly disposing of this product, you are also con-
tributing to the effective use of natural resources.
You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body
for the disposal of waste electrical and electronic
equipment or your waste disposal company.

13. Troubleshooting

Warning: In the interests of operational safety, always switch off the saw and remove the mains plug before carrying out
maintenance work.
Fault
Tension incorrectly set
Load to great
Saw blades break
Incorrect saw blade variety
Workpiece not fed straight
Mains Gable faulty
Motor faulty
Motor does not function
Saw incorrectly installed
Unsuitable underlay
Vibration
NOTE: The saw vibrates
slightly when the motor
is running in normal
operation.
The work bench is not screwed
down or is on the motor
The motor is not secured
Saw blade swings out Holders not aligned
Holders not aligned
straight
24 | GB
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Possible causes
Batteries and rechargeable batteries do not be-
long in the household waste!
As the consumer you are required by law to
bring all batteries and rechargeable batteries,
regardless whether they contain harmful sub-
stances* or not, to a collection point run by the local
authority or to a retailer, so that they can be disposed
of in an environmentally friendly manner.
*labelled with: Cd = cadmium, Hg = mercury, Pb =
lead
• Remove the batteries from the laser before dispos-
ing of the machine and the batteries.
Action
Set the correct tension
Feed the workpiece more slowly
Use the correct saw blades
Avoid exerting pressure from the side
Change faulty parts
Call customer service. Do not attempt to repair
the motor yourself as this should be carried out by
trained personnel.
Refer to the instructions given earlier in this manual
for information on installing the saw
The heavier the work bench is,the less the vibration.
A bench made from ply wood always vibrates more
than one made from solid wood. Select the work
bench best suited to your working conditions
Tighten the locking lever
Securely screw the motor in place
Loosen the screws with which the holders are fas-
tened to the arm. Align the holders so that they are
perpendicular to each other and retighten the screws.