Specifications; Additional Safety Rules - Makita 4105KB Betriebsanleitung

ENGLISH
1 Blade cover
2 Wrench
3 Diamond wheel
4 Outer flange
5 Socket wrench
6 Tighten

SPECIFICATIONS

Model
Blade diameter ............................................. 125 mm
Max. cutting capacity ..................................... 40 mm
No load speed (RPM) ...................................... 7,500
Overall length ............................................... 230 mm
Net weight ....................................................... 3.2 kg
• Due to the continuing program of research and
development, the specifications herein are subject
to change without prior notice.
• Note: Specifications may differ from country to
country.
Power supply
The machine should be connected only to a power
supply of the same voltage as indicated on the
nameplate, and can only be operated on single-phase
AC supply. They are double-insulated in accordance
with European Standard and can, therefore, also be
used from sockets without earth wire.
Safety hints
For your own safety, please refer to enclosed safety
instructions.
These symbols mean:
Read instruction manual.
DOUBLE INSULATION

ADDITIONAL SAFETY RULES

1. Check the wheel carefully for cracks or dam-
age before operation. Replace cracked or
damaged wheel immediately.
2. Use only flanges specified for this machine.
3. Be careful not to damage the spindle, flanges
(especially the installing surface) or bolt. Dam-
age to these parts could result in wheel break-
age.
4. Hold the machine firmly.
5. Keep hands away from rotating parts.
6. Make sure the wheel is not contacting the
workpiece before the switch is turned on.
7. Wait until the wheel attains full speed before
cutting.
8. Stop operation immediately if you notice any-
thing abnormal.
9. Do not attempt to lock the trigger in the ''ON''
position.
10. Never attempt to cut with the machine held
upside down in a vise. This can lead to serious
accidents, because it is extremely dangerous.
(Fig. 1)
4
Explanation of general view
7 Loosen
8 Inner flange
9 Hex bolt
0 Wing nut
q Base
w Dust spout
11. Before setting the machine down after com-
4105KB
SAVE THESE INSTRUCTIONS.
OPERATING INSTRUCTIONS
Removing or installing diamond wheel
(Fig. 2, 3 & 4)
Important:
Always be sure that the machine is switched off and
unplugged before removing or installing the wheel.
Remove the blade cover.
Hold the outer flange with the wrench and loosen the
hex bolt clockwise with the socket wrench. Then
remove the hex bolt, outer flange and wheel.
To install the wheel, follow the removal procedure in
reverse.
BE SURE TO TIGHTEN THE HEX BOLT SECURELY.
CAUTION:
Use only the Makita wrench and socket wrench to
install or remove the wheel.
Adjusting depth of cut (Fig. 5)
Loosen the wing nut on the depth guide and move the
base up or down. At the desired depth of cut, secure
the base by tightening the wing nut.
CAUTION:
After adjusting the depth of cut, always tighten the
wing nut securely.
Dust bag (Fig. 6)
The use of the dust bag makes cutting operations
clean and dust collection easy. To attach the dust bag,
fit it onto the dust spout. When the dust bag is about
one-third full, remove the dust bag from the machine
and pull the fastener out. Empty the dust bag of its
contents, tapping it lightly so as to remove particles
adhering to the insides which might hamper collec-
tion.
Sighting (Fig. 7)
Align the notch in the front of the base with your
cutting line on the workpiece.
e Switch trigger
r Restart button
t Limit mark
y Brush holder cap
u Screwdriver
pleting a cut, be sure that the wheel has come
to a complete stop.