Setting the motion detector
The range, light sensitivity and duration of the beam are adjusted
using the LUX control
, TIME control
and SENS control
on the
motion detector
.
Light sensitivity (LUX
)
Set the light sensitivity here, i .e . the degree of darkness under which
the motion detector
should activate .
Preferably, set the light sensitivity at the time of day when the motion
detector
should switch on .
The brightness sensor can be set between 5 Lux
and 20,000 Lux .
Light duration (TIME
)
This setting governs how long the light will stay illuminated after
registering a movement . You can set a light duration of between
10 seconds and 4 minutes . If the appliance is switched on and a
new movement is registered, the light duration will be extended by
the set time .
Range (SENS
)
This setting governs the sensitivity range of the motion detector
.
You can set the range up to a maximum of 12 m .
GB │ IE │ NI
│
13
■
LSLB 10 B2