Electrical connection
DANGER
Risk of fatal injury from electrocution!
►
The electrical installation may only be carried out by a qualified
electrician .
►
During assembly, all corresponding standards must be complied
with .
►
Switch off the electricity at the fuse box before assembly/instal-
lation .
WARNING
This appliance complies with protection class I .
►
The protective earth (green/yellow wire) must be connected to
the point marked
♦
Undo the four screws on the connection box
appliance and remove the cover .
♦
Unscrew the cable gland
♦
Place the cable gland
the power cable (not supplied) .
♦
Pull the power cable through the cable entry
box
.
♦
Fix the cable in place using the cable clip (see connection diagram) .
♦
Screw the cable gland
the cable entry
LSLB 10 B2
.
and remove the rubber seal .
and the rubber seal with the flat side on
together with the rubber seal firmly into
.
on the rear of the
into the connection
GB │ IE │ NI
│
11
■