Mounting The Solar Cell; Preparing The Product For Use; Switching The Motion Detector On And Off; Setting The Lighting Duration - LIVARNOLUX HG01045 Montage-, Bedienungs- Und Sicherheitshinweise

Install the main station onto the wall bracket
(see Fig. F).
Check that the main station is fitted securely.

Mounting the solar cell

When selecting the mounting location for the solar
cell , pay attention to the following:
13
– The solar cell needs to be as directly exposed
to sunlight as possible. Even partial shading of
the solar cell during the day can have a signifi-
cant influence on charging.
Cardinal direction:
Orientation towards the south is optimum. Orienta-
tions with slight deviations towards the west are
preferable to those with slight deviations towards
the east.
Horizontal orientation:
The horizontal orientation of the solar cell depends
on the geographic latitude of the mounting location.
In central Europe, and angle of 30°–40° is ideal.
Drill 4 holes. Mount the solar cell by using
the dowel (ø 6 mm) and screws
21
(ø 3.7 x 28 mm). To do so, use the pre-finished
mounting holes (see Fig. E).
After mounting, check that the solar cell is fitted
securely.
Note: After mounting, orient the solar cell by
tilting it. The solar cell is fitted with a joint which
locks every 18° to permit orientation.

Preparing the product for use

Switching the motion detector
on and off
Slide the AUTO / OFF switch
position to switch on the motion detector
Slide the AUTO / OFF switch into the OFF posi-
tion to switch off the motion detector.
14
into the AUTO
4
.
6

Setting the lighting duration

Turn the rotary control TIME
of the motion detector
the duration of the illumination. The lighting
duration can be adjusted within a time window
of approx. 10–60 seconds.
Adjusting the sensitivity of
the sensor
Turn the rotary control SENS
of the motion detector
crease the sensitivity of the sensor.
Note: The motion detector responds to heat
radiation. When outdoor temperatures are low,
it is more sensitive to body heat than when out-
door temperatures are warm. Be sure to regu-
late the sensitivity of the sensor over the course
of the year.

Setting the daylight level

Turn the rotary control LUX
the motion detector
6
the daylight level. In position , the motion
detector only responds at pitch-black night
(approx. 50 lx). In position , the motion
detector also responds at daylight levels, as
long as about 20,000 lx are not exceeded.
Orientating the motion
detector
Loosen the fastening screws
detector .
6
Turn the rotary control LUX
Orient the motion detector into the central
region of the desired coverage area.
Move about through the coverage area until
you are satisfied with the response characteris-
tics of the motion detector. To find the proper
orientation, change the position of the rotary
on the bottom
10
clockwise to increase
6
on the bottom
9
clockwise to in-
6
on the bottom of
8
clockwise to increase
of the motion
5
to position .
8
GB/IE 9