Setting The Motion Detector - LIVARNOLUX LSLB 10 B2 Bedienungsanleitung

Setting the motion detector

The range, light sensitivity and duration of the beam are adjusted
using the LUX control , TIME control and SENS control on the
motion detector .
Light sensitivity (LUX )
Set the light sensitivity here, i.e. the degree of darkness under which
the motion detector should activate.
Preferably, set the light sensitivity at the time of day when the motion
detector should switch on.
The brightness sensor can be set between 5 Lux and 20,000 Lux .
Light duration (TIME )
This setting governs how long the light will stay illuminated after
registering a movement. You can set a light duration of between
10 seconds and 4 minutes. If the appliance is switched on and a
new movement is registered, the light duration will be extended by
the set time.
Range (SENS )
This setting governs the sensitivity range of the motion detector .
You can set the range up to a maximum of 12 m.
GB │ IE │ 33 ■
LSLB 10 B2