Start-Up; Adjusting The Motion Detector; Setting The Lighting Duration; Adjusting The Sensitivity Of The Sensor - LIVARNOLUX HG03444A Montage-, Bedienungs- Und Sicherheitshinweise

then by turning the nut of the
cable gland
Connect the lead of the cable
with the terminal block
the connection box
tention to the markings on the
terminal block
for neutral and
wire) (Fig. C).
Close the connection box
Align the spotlight
desired direction. For this, you
may need to slacken the fasten-
ing screws
8
alignment, tighten the fastening
screws again, to ensure a
8
secure hold.
Reinsert the fuse or switch the circuit
breaker back on. Your product is
now ready to use.

Start-up

Adjusting the
motion detector
Depending on the pre-adjustments
of the motion detector
light will switch itself on for a
1
.
7
in
13
. Pay at-
6
(L for live, N
13
for the earth
.
6
into the
1
. After finish the
, the spot-
9
certain period of time as soon as
the motion detector
movement. These pre-adjustments
are made using the three controllers
on the underside of the motion
detector (Fig. B).
9
Setting the
lighting duration
Turn the rotary control TIME
clockwise to increase the dura-
tion of the illumination. The
lighting duration can be adjusted
within a time window of approx.
10 seconds to 4 minutes.
Adjusting the
sensitivity of the
sensor
Turn the rotary control SENS
clockwise to increase the sensi-
tivity of the sensor.
Note: The motion detector
responds to heat radiation.
When outdoor temperatures
are low, it is more sensitive to
body heat than when outdoor
detects
9
11
10
9
GB/CY 11