Replacing A Led Bulb; Adjusting The Motion Sensor; Setting The Lighting Duration - LIVARNOLUX HG05862A Montage-, Bedienungs- Und Sicherheitshinweise

nection housing
secure with the two nuts
Check for correct fitting.
Insert the LED bulb
a ¼ turn in a clockwise direction (see fig. G).
Place the lamp shade
sealing ring on the lamp body
in contact (see fig. H).
Re-install the fuse for this circuit or switch on at the circuit breaker in the fuse box
(see fig. J). Your product is now ready to use.

Replacing a LED bulb

CAUTION! RISK OF ELECTRIC SHOCK!
To replace the LED bulb
circuit. To do this, remove the fuse or switch off the circuit breaker in the fuse
box (0 setting).
Allow the product to cool completely.
Remove the lamp shade
Turn the defective LED bulb
Use a dry, lint-free cloth to replace a LED bulb
Insert a new LED bulb
Check for correct fitting.
Place the lamp shade
sealing ring makes contact with the lamp shade.
Re-install the fuse for this circuit or switch on at the circuit breaker in the fuse box.

Adjusting the motion sensor

Depending on the preadjustments of the motion sensor
itself on for a certain period of time as soon as the motion sensor
These preadjustments are made using the three controllers on the underside of the
motion sensor (see fig. I).
15

Setting the lighting duration

Turn the rotary control TIME
nation. The lighting duration can be adjusted within a time window of approx.
10 seconds to 5 minutes.
, attach the silicon washers
7
.
5
into the socket carefully with a cloth and tighten it with
14
on the lamp body
1
and lower lamp shade
2
, first of all disconnect the product from the mains
14
from the lamp body
1
out of the socket with a ¼ turn anticlockwise.
14
in the socket and tighten it with a ¼ turn clockwise.
14
over the lamp body
1
clockwise to increase the duration of the illumi-
18
, flat washers
3
and tighten it. Ensure that the
2
are present and
1
.
2
.
14
and screw tight. Be sure the
2
, the product will switch
15
detects movement.
15
and
4
GB/IE 19