Assembly/Electrical Connection; Selecting The Set-Up Location; Assembly - LIVARNOLUX LSLB 10 B2 Bedienungsanleitung

Assembly/electrical connection

Selecting the set-up location

The appliance can be set up indoors or in a roofed location outside .
DANGER
► Keep the appliance at a sufficient distance (at least 0 .5 m) from
the illuminated surface . Otherwise, there is a risk of fire due to
heat building up .
NOTE
► You can mount the appliance on ceilings or walls .
The maximum installation height is 2 m .
You can set the range of the motion detector
12 m . The motion detector
180° .
The LED beam angle is approximately 120° .
When selecting the installation location, make sure that the beam does
not fall on any areas you do not wish to illuminate, such as streets or
lights, and that no objects block the beam .

Assembly

DANGER
Risk of fatal injury from electrocution!
► The electrical installation may only be carried out by a qualified
electrician .
► During assembly, all corresponding standards must be complied
with .
► Switch off the electricity at the fuse box before assembly/instal-
lation .
LSLB 10 B2
has a detection range of up to around
up to a maximum of
GB │ IE │ NI │ 9 ■