9. Selection of camera channel on the monitor
To select the desired camera channel, press the channel selection button several times (15). The cam-
era channel shown on the display (14) is confirmed by the green light of the channel status LED (16).
Channel status LED CH1
Channel status LED CH2
Channel status LED CH3
Channel status LED CH4
Make sure that the channel switch (7) on the wireless camera is not in the OFF posi-
tion.
10. Setting the volume
Turn the volume control (18) in the desired direction to set the volume of the loudspeaker (17).
11. Switching the monitor on/off
Turn on the monitor by putting the ON/OFF switch (19) in the ON position. Turn off the monitor by putting
the ON/OFF switch (19) in the OFF position.
12. Maintenance and cleaning
Before cleaning the housing of the surveillance camera and the monitor, separate them from the mains
voltage and disconnect the wall power supply from the mains socket.
A clean, dry and soft cloth is sufficient to clean the outside of the camera and the monitor. For more resis-
tant dirt on the camera, you can moisten the cloth with lukewarm water.
Clean the camera lens very carefully, you may otherwise scratch it. Do not apply too much pressure on
the glass front of the camera or the monitor display as they might break.
Apart from replacing the battery as described, no parts need servicing.
=
camera channel 1
=
camera channel 2
=
camera channel 3
=
camera channel 4
27