Troubleshooting - STEINEL IS 3360 MX DALI Bedienungsanleitung

IS 3180 DALI IS 3360 DALI
IS 3360 MX DALI
User-friendly
DALI function,
ON, OFF, 10 - 30 min, all night, 10 - 50%
Basic bright-
ness
Time setting
Twilight setting
Manual override
(permanent light)
IP rating Surface-mounted: IP 54 Concealed: IP20
Temperature
zone
12� Troubleshooting
Malfunction Cause
No power at the sensor
n Fuse faulty,
not switched ON,
break in wiring
n Short circuit
Sensor will not switch ON n Twilight setting in night
mode during daytime
operation
n Bulb faulty
n Mains power switch
OFF
n Fuse faulty
n Detection zone not
properly targeted
Sensor will not switch OFF n Continuous movement
in the detection zone
n Light being operated
is located in detection
zone and keeps switch-
ing ON as a result of
temperature change
n Light being operated
is in manual override
mode (LED ON)
IS 345 DALI IS 345 MX DALI
5 s - 15 min
2 – 1000 lux + teach mode
selectable (4 h)
-20°C to +50°C
Remedy
n New fuse, turn ON
power switch, check
wiring with voltage tester
n Check connections
n Adjust setting
n Change bulb
n Switch ON
n Fit new fuse, check
connection if necessary
n Readjust
n Check zone, adjust or fit
shrouds if necessary
n Change detection zone
or fit shrouds
n Deactivate manual
override
34
Malfunction Cause
Sensor keeps switching
n Light being operated
ON/OFF is located in detection
zone
n Animals moving in
the detection zone
Sensor reach
n Differing ambient
change
temperatures
Sensor responds
n Wind is moving trees
when it should not and bushes in the
detection zone
n Cars on the road are
being detected
n Sunlight is shining
on the lens
n Sudden change in
temperature caused
by weather (wind, rain,
snow) or air discharged
from fans, open windows
n Dazzle guard active
n Sensor near Wi-Fi
or other wireless
communication source
Remedy
n Change zone or
fit shrouds,
increase distance
n Change detection zone
or fit shrouds
n Use shrouds to define
detection zone precisely
n Change detection zone
n Change detection zone
n Mount sensor in a
sheltered place or
change detection zone
n Change detection zone,
mount in a different
place
n Switch OFF manually
via button/switch
n No movement detected
within the selected
stay-ON time + 60 sec
(dazzle guard)
n install at least 2 m
away from the wireless
communication source
35