Technical Specifications; Troubleshooting - STEINEL HF 3360 DALI Montageanleitung

10� Technical specifications
Dimensions Surface-mounted installation, round Ø 126 × 52 mm
(L × W × H) Surface-mounted installation, square
Concealed installation, round Ø
Concealed installation, square
Mains power supply 220 - 240 V, 50 / 60 Hz max. 2.5 mm
Angle of coverage 360° with 180° angle of aperture
Application inside buildings
Sensor system 5.8 GHz high frequency
Transmitter power approx. 1 mW
Time setting 5 s - 15 min
DALI output 2-core DALI control cable / broadcast
Controllable DALI
30
electronic ballasts
User-friendly DALI function,
ON, OFF, 10 - 30 min, all night, 10 - 15%
Basic brightness
Twilight setting 2-1000 lux + teach mode
Manual override
selectable (4 h)
(permanent light)
IP rating Surface-mounted: IP54
Temperature range - 20°C to + 50°C
Mounting height 2 - 2.8 m
95 × 95 × 52 mm
124 × 64 mm
94 × 94 × 64 mm
2
Concealed: IP20
24
11� Troubleshooting
Malfunction Cause
No power at the sensor
n Fuse faulty,
not switched ON
n Short circuit
n Additional two-way
switch OFF
n Fuse faulty
Sensor will not switch ON
n Bulb faulty
n Twilight setting
set to night-time mode
during daytime operation
n Additional two-way
switch OFF
n Fuse faulty
Sensor will not switch OFF n Continuous movement
in the detection zone
n Manual override acti-
vated (red LED lights up)
n Another sensor
is parallel-connected
and still active
Sensor keeps switching n Curtains, plant etc.
ON/OFF
moving in the sensor's
detection zone causing
the sensor to respond
n n Sensor near Wi-Fi
or other wireless
communication source
Remedy
n Replace fuse, turn ON
power switch, check
lead with voltage tester
n Check connections
n Switch ON
n New fuse, check
connections if necessary
n Change bulb
n Adjust setting
n Switch ON
n Fit new fuse, check
connection if necessary
n Check zone
n Deactivate manual
override
n Wait for time setting
of the other sensor
to elapse
n Check zone
n install at least 2 m
away from the wireless
communication source
25