Troubleshooting - Scheppach 4903303924 Originalbetriebsanleitung

DE GB

13. Troubleshooting

Problem
Motor
doesn't start
Machine
gets slower during work.
Sanding belt comes off
the drive pulleys.
The wood gets burnt
during
sanding.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
FR CZ SK DK
Possible Cause
a) ON/OFF switch damaged.
b) ON/OFF cable damaged.
c) ON/OFF relay damaged.
d) Fuse blown.
e) Motor burnt.
Too much pressure put on the workpie-
ce.
Belt does not run straight.
a) Sanding disc or belt covered with
grease.
b) Excessive pressure on workpiece.
ES FIN IT NL PL
Action
a-d) Replace all damaged parts before you use
your machine again.
e) Contact your local service centre. Every at-
tempt to carry out a repair, can be dangerous if
it is not done by skilled personnel.
Reduce the pressure on the workpiece.
Reset the track.
a)Replace disc or belt.
b) Reduce pressure on workpiece.
PT SE SI NO
23 / 136