Declaration Of Conformity - Jackle Plasma 40i IP44 Betriebsanleitung

General information's:
These operating instructions are intended to ensure safe and efficient work with this welding unit.
Prior to initial operation of the unit, read the instructions carefully.
The information contained in this manual should be made available to all operational staff. These in
structions should always be kept ready-to-hand, near the machine.
Electromagnetic compatibility EMC (IEC 60974-10):
WARNING: This class A welding unit is not provided for use in housing areas, where the electric
power supply comes from a public low voltage supply.
It may possible, that through wire fixed or radiate disturbances, it isn't easy to guarantee electromag
netic compatibility in these areas.
INFORMATION: The user is responsible for the trouble, which the machine generates during the
operation. He must rate and consider possible electromagnetic problems in the neighbourhood.
Warranty:
INFORMATION: Improper repair or servicing, technical modifications of the product, unauthorized,
not strictly from JÄCKLE GmbH permitted modifications, as well as carelessness at the installation or
use, or the nonobservance of care in own affairs lead to the extinction of every warranty.
Manufacturer:
We declare, that below mentioned current source corresponds to the safety requirements of the
recommendations.
Name of unit:
Type of unit:
Relevant EC recommendations:
EMC – Directive
Low voltage Directive
Applied harmonized standards:
EN 60 974 – Part 1
EN 60 974 – Part 10
Additional information:
Restrictive use, Class A equipment
Jäckle Schweiß- und Schneidtechnik GmbH
Reinhard Jäckle
Operating manual

DECLARATION OF CONFORMITY

Jäckle Schweiß- und Schneidtechnik GmbH
Riedweg 4+9
D – 88339 Bad Waldsee
Germany
Plasma cutting unit
Plasma 40i
2004/108/EG ( since 20.07.2007 )
2006/95/EG ( since 16.01.2007 )
Arc welding equipment / Welding power sources
EMC product standard for arc welding equipment
Plasma 40i
Page 12