Electrolux EOC3410 Benutzerhandbuch Seite 19

Removing the shelf supports
1
Installing the shelf supports
Install the shelf supports in the opposite
sequence.
The rounded ends of the shelf
supports must point to the front.
9.2 Pyrolysis
WARNING!
The appliance becomes very hot.
There is a risk of burns.
CAUTION!
If a hob is installed with the appli-
ance, do not use it at the same
times as the Pyrolysis function. It
can cause damage to the appli-
ance.
1. Remove the removable shelf supports
(if applicable) and accessories from
the appliance. Refer to "Removing the
shelf supports".
CAUTION!
Do not let the removable shelf
supports stay in the appliance
during the cleaning procedure.
There is a risk of damage.
2. Remove the worst dirt manually.
2
1.
Pull the front of the shelf support away
from the side wall.
2.
Pull the rear end of the shelf support
away from the side wall and remove
it.
3. Fully close the oven door.
The cleaning procedure cannot
start if you do not close the oven
door.
4. Set the function Pyrolysis. Refer to
"Oven functions".
5.
When flashes, press + or - to set
the necessary procedure:
– P1 - if the oven is not very dirty.
The procedure is 1 h long.
– P2 - if the oven is more dirty. The
procedure is 1 h 30 min long.
6.
Press to start the procedure. You
can use the End function to delay the
start of the cleaning.
When the oven is at the set tempera-
ture, the door locks. The display
shows the symbol
the heat indicator.
To stop Pyrolysis before it is com-
pleted, turn the knob for the oven
functions to the off position.
When Pyrolysis is completed, the display
shows the time of day. The oven door
stays locked. When the appliance is cool
again, an acoustic signal sounds and the
door unlocks.
ENGLISH 19
and the bars of