Herunterladen Inhalt Inhalt Diese Seite drucken

Use; Cleaning; Emptying The Dust Bin - Cleanmaxx Z 08749 Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Use

ATTENTION!
❐ Keep the nozzles, the handle and the telescoping tube away from body parts and
pets. They could be caught by the vacuum cleaner. If the vacuum cleaner does hap-
pen to get caught, immediately press the On/Off switch to turn off the device.
❐ Only turn on the vacuum cleaner once you are sure that all parts have been com-
pletely mounted and that the dust bin and the fi lters have been properly inserted.
❐ Do not in any case vacuum up the following:
– Liquids or wet materials (such as wet carpet shampoo)
– smouldering ashes, cigarette butts, matches etc.
– fl ammable or ignitable materials
– very fi ne dust (e. g. concrete dust), ash or toner
– hard, pointy objects such as glass shards
An auxiliary air valve is located on the handle, which you can use to reduce
the suction power if needed. Open the valve if you want to vacuum off curtains,
carpets or other lightweight, moveable objects or materials. Otherwise keep
the valve closed.
1. Pull out the length of mains cord that you need. Do not forcefully pull the cord out
up to the stop. Do not pull it out any further than to the red mark. The yellow mark
indicates the ideal cord length.
2. Connect the mains plug to a properly installed socket.
3. Press the On/Off switch to turn the vacuum cleaner on.
4. Move the nozzle over the surface you want to clean.
5. After vacuum cleaning, press the On/Off switch to turn off the vacuum cleaner.
6. Remove the power plug from the socket. Firmly hold the mains cord and push the
button to recoil the mains cord. By holding the cord, you prevent it from "whiplashing"
against body parts such as your legs.

Cleaning

ATTENTION!
❐ Always pull the mains plug out of the socket before cleaning the fi lters and emptying
the dust bin.
❐ Do not use any corrosive or abrasive cleaning agents or cleaning pads to clean the
vacuum cleaner housing. They could damage the surface.

Emptying the dust bin

1. Depress the release button and at the same time, pull the dust bin out from above.
2. Hold the dust bin over an open garbage bin.
3. Push down on the dust bin fastener. The container lid will open and you can empty
the container.
4. Close the lid of the dust bin. The fastener must lock into place. Help closing the lid if
necessary by pushing the fastener up against the dust bin lid.
20

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis