Preparing The Measurement - Beurer BM 55 Gebrauchsanweisung

Information on the display:
1. Date / time
2. Systolic pressure
3. Diastolic pressure
4. Pulse value
5. Pulse symbol
6. Release air (arrow)
7. Number of memory
space/memory display
average value ( ),
morning ( ),
evening ( )
8. Battery replacement
symbol
9. User memory
10. WHO classification
11. Cardiac arrhythmia symbol
Computer interface
The blood pressure monitor also allows you to transfer your
measured values to the computer.
For this, you will need a standard USB cable (included in deliv-
ery) and the HealthManager computer software.
The software can be downloaded free of charge from the
download area under Service at www.beurer.com.
System requirements for the HealthManager computer
software
1. Supported operating systems:
• Windows XP SP3
• Windows Vista SP1 or later
11
10
9
8
7 6 5
• Windows 7
• Windows 7 SP1
1
• Windows 8
2. Supported architectures:
• x86 (32 Bit)
2
• x64 (64 Bit)
3. Hardware requirements:
• Recommended: At least Pentium 1 GHz or faster
with at least 1 GB RAM
3
• Free memory on the primary partition of at least:
– x86 – 600 MB
4
– x64 – 1.5 GB
• Display resolution from: 1024 x 768 pixels
• USB port 1.0 or later

4. Preparing the measurement

Inserting the batteries
• Remove the battery compart-
ment lid on the rear of the
device.
• Insert four 1.5 V AAA (alkaline
type LR03) batteries. Make
sure that the batteries are
inserted the correct way round.
Do not use rechargeable bat-
teries.
• Close the battery compartment
lid again carefully.
All display elements are briefly displayed,
display. Set the date and time as described below.
21
4 x 1,5V AAA (LR03)
flashes in the