ATIKA BioQuick 2500 Originalbetriebsanleitung Seite 15

O p e r a t i o n a l f a u l
O p e r a t i o n a l f a u l
Before each fault elimination:
− Switch off device.
− Wait for standstill of the garden shredder.
−
Pull out mains plug.
Fault
Motor does not start.
Motor hums,
but does not start.
Reduced cutting perform-
ance.
Device starts but blocks
under slight load and cuts off
via protective motor switch.
T e c h n i c a l d a t a
T e c h n i c a l d a t a
Model
Name
Motor
Motor rating P S6 - 40 %
1
Current consumption I
ON/OFF-switch with
Weight
Sound pressure level at work L
(measured to 2000/14/EC)
Measured sound power level L
(measured to 2000/14/EC)
Guaranteed sound power level L
(measured to 2000/14/EC)
Max. branch diameter
(only for freshly cut wood)
Safety class
Protection class
Mains fuse
Switzerland
UK
14
t s
t s
Possible cause
− No power supply.
− Mains cable defective.
− Upper part of the enclosure not properly
closed (safety shut-off is activated).
− Cutters blocked.
− Capacitor faulty.
Knife edges became blunt.
Extension cable too long, or cross-section
too small. Socket too far from mains sup-
ply and cross-section of mains cable too
small.
PA
WA
WA
Removal
− Check fuses.
− Have these checked (electrician).
− Close and bolt down upper part of the enclosure cor-
rectly, remove any dirt present.
− Switch machine off, disconnect mains plug, and clean
interior of machine.
− Have machine repaired by manufacturer or approved
company.
Turn the knife or replace it with a new set of knives.
Extension cable at least 1.5 mm², maximum 25 m long. If a
longer cable is used, minimum cross-section 2.5 mm².
2300
AH 501
AC-Motor 230 V~, 50 Hz, 2800 rpm, including automatic motor brake
2300 W
10,4 A
Motor protection switch, electrical safety cut-out, zero-voltage initiator
18,5 kg
83 dB (A) / K = 3 dB (A)
∅ max. 40 mm
16 A time-lag
10 A time-lag
13 A time-lag
2500
AH 500
2500 W
11,3 A
18,5 kg
103 dB (A)
104 dB (A)
∅ max. 40 mm
I
IP X4
16 A time-lag
13 A time-lag
--