Technical Data; Declaration Of Conformity; Noise/Vibration Information; Mounting And Operation - Bosch GST 90 BE Professional Originalbetriebsanleitung

OBJ_BUCH-1231-005.book Page 12 Monday, May 26, 2014 12:43 PM
12 | English

Technical Data

The technical data of the machine are listed in the table on
page 182.
The values given are valid for a nominal voltage [U] of 230 V.
For different voltages and models for specific countries,
these values can vary.

Declaration of Conformity

We declare under our sole responsibility that the product de-
scribed under "Technical Data" is in conformity with all rele-
vant provisions of the directives 2011/65/EU, 2014/30/EU,
2006/42/EC including their amendments and complies with
the following standards: EN 60745-1, EN 60745-2-11.
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ETM9,
70764 Leinfelden-Echterdingen, GERMANY
Henk Becker Helmut Heinzelmann
Executive Vice President Head of Product Certification
Engineering PT/ETM9
Robert Bosch GmbH, Power Tools Division
70764 Leinfelden-Echterdingen, GERMANY
Leinfelden, 05.05.2014

Mounting and Operation

The following table indicates the action objectives for mounting and operation of the power tool. The instructions for each action
objective are shown aside. Depending on the type of application, various instruction combinations are required. Observe the
safety instructions.
Action
Inserting the Saw Blade
Ejecting the Saw Blade
Switching on the sawdust blower
device
Connecting the dust extraction
Adjusting the Cutting Angle
1 609 92A 0KR | (26.5.14)

Noise/Vibration Information

The measured values of the machine are listed in the table on
page 182.
Sound emission values determined according to
EN 60745-2-11.
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 60745.
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with anoth-
er. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different
applications, with different accessories or insertion tools or is
poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working
period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work pat-
terns.
Figure Please observe
1
2
3
4
5
Page
183
183
183
184–185
185–186
Bosch Power Tools