Electrical Safety - Ferm CDM1085 Gebrauchsanweisung

GB
Donotthrowthebatteryintofire
Donotthrowthebatteryinthewater
Important safety notes on charger and
battery block
Ifyoucomeincontactwithacidfromthe
 
batteryblock,rinseitoffwithwater
immediately.Ifacidgetsintoyoureyes,
rinseoutyoureyesatoncewithwater
andcontactadoctorimmediately!
1. Read and note the operating instructions and
safety notes for the charger and battery block
before use!
2. NB! Only use the charger and battery block
that were supplied by the manufacturer -
otherwise you will risk an accident.
3. Protect the charger, battery block and power
tool from moisture, e.g. rain or snow.
4. lways check that all cables are connected
correctly before using the charger.
5. If you discover that a cable is damaged, you
should not use the charger again. Have the
damaged cable replaced immediately.
6. When the charger is not in use, it should be
removed from the power socket. Do not pull
out the charger by grasping the cable.
7. If the charger has been dropped or has
otherwise been exposed to high mechanical
stresses, you should have it checked for
damage by an authorised dealer before using
it again. Damaged parts should be repaired.
8. Exercise caution when handling the battery
block and do not drop it or expose it to impacts.
9. Never attempt to repair the charger or
battery block yourself. Repairs must always
be carried out by an authorised dealer -
otherwise you risk an accident.
10. Before cleaning or servicing the charger or
battery block, always pull the plug from the
charger socket.
11. Never charge the battery block when the
ambient temperature is below 5 °C or above
40 °C.
12. The battery block must not be short-circuited.
short-circuitwillcauseahighcurrent
toflow.Thismayresultinoverheating,
thedangeroffireorexplosionofthe
batteryblock.Thismaydamagethe
6
batteryblockortheusermayriskanaccident.
Therefore:
•
 Donotconnectanycablestothepolesof
thebatteryblock.
•
 Takecarethattherearenometalobjects
(nails,paperclips,coins,etc.)onthe
contactsurfaceofthebatteryblock.
•  Donotexposethebatteryblocktowateror
rain.
•  Onlyusethebatteryblocksupplied
incombinationwiththiscordlessdrill/
screwdriversoastoavoidfaultsand/or
riskstopersons.
13. damaged battery block or one that can
no longer be charged must be disposed
of as special waste. Do not discard it with
household waste.
14. Never throw the battery block onto a fire or
into water. This will risk explosion!

Electrical safety

lwayscheckthatthevoltageonthe

batteryblockcorrespondstothevoltage
ontheratingplate. lsocheckthatyour
mainsvoltagecorrespondstotheinput
voltageofthebatterycharger.
ClassIImachine–Doubleinsulation–
Youdon'tneedanyearthedplug.
Replacing cables or plugs
Immediately throw away old cables or plugs when
they have been replaced by new ones.
• Remove the battery block when the power tool
is not being used and prior to maintenance.
• The tool is suitable for use as a screwdriver
and drill. ny other application is specifically
excluded.
3. MOUNTING CCESSORIES
Priortomountinganaccessoryalways
removethebattery.
Ferm