Safety Socket Connection With Conventional Brake Lights; Safety Socket Connection With Led Brake Lights - Truma Mover H Se R Gebrauchsanweisung

Safety socket connection with conventional
brake lights
(applies to 7-pin and 13-pin sockets!)
The fact that there are two conventional brake lights and
a third brake light with LED technology does not affect
this connection.
Route the provided 2-wire cable (10 m) with the wire-end fer-
rules through the socket holder (g) and the rubber sleeve (h).
Open cover and push socket connection out of socket housing (i).
Connect wire with longitudinal red stripe to pin 6 and black
wire to pin 3 (pin designation printed on connection and on
inside of cover).
Re-insert socket connection into socket housing (i).
Screw socket housing (i) to socket holder (g) using 3 sheet
metal screws (j). (Several alternative positions are available
by using the mounting holes in the socket holder and rotating
the rubber seal).
Loosely route cable through strain relief (k) and secure with
2 sheet metal screws. Depending on the installation situation,
the cable can be led out of the socket holder through one of
the three recesses.
Pin 6
g
Pin 3
PT 4 x 10
Secure safety socket to the
(plastic) shaft cover of the
caravan with 4 bolts, nuts and
washers.
No holes must be drilled
in the chassis.
Alternatively, the safety socket
can be secured using the two
worm drive hose clamps.
Route wire connected to pin 6 (with red stripe) to control unit
(shorten if necessary), crimp on a flat plug and connect as
shown in the connecting diagram.
Route wire connected to pin 3 (black) to control unit (shorten
if necessary), crimp on a ring and screw to negative battery
terminal as shown in connecting diagram.
i
B 3.9 x 33
(3 x)
h
j
M 4 x 16
(4 x)
Washer 4,3
(4 x)
Nut M 4 (4 x)
The connection to the control unit must be made in the
order – nut, battery negative terminal ring, nut, cable
pin 3 ring, nut.
Re-check whether all cables are correctly connected, attached
using the provided clips and cannot chafe.

Safety socket connection with LED brake lights

This connection must always be used if all brake lights
are of the LED variety! With two conventional brake
lights and a third brake light with LED technology, the connec-
tion is made as described in "Safety socket connection with
conventional brake lights".
7-pin safety socket
Connect pin 3 of the caravan plug to the negative battery
terminal.
Connect pin 3 of the safety socket to the controller (with
one wire of the 2-wire cable).
13-pin safety socket
Connect pin 11 of the caravan plug to the negative battery
terminal.
Connect pin 11 of the safety socket to the controller (with
one wire of the 2-wire cable).
If it is not possible to make a connection using pin 11 (pin
missing, for example), use pin 3 as an alternative.
It must be ensured that ground connections pin 11
and pin 3 are not interconnected in an electrically
conductive manner at the trailer side!
Connecting diagram with LED brake lights
Fuse
k
Engagement
motors
– + – +
6
Safety
socket
5
7-pin
Caravan 6
plug
5
Drive Drive-
motor motor
Safety
Battery
contact
– +
4 3 2
8
1
7 9
2
1
6 10
7
4 2
-
3
11
5 3
4
13 12
13-pin
8
1
7 9
2 1
6 10
7
4 2
3
11
5 3
4
13 12
1 1
+
21