Adjusting The Sound - JVC ks-lh60r Bedienungsanleitung

Adjusting the sound

You can adjust the sound characteristics to your
preference.
1
Select the item you want to adjust.
BAS
(bass)
VOL
(volume)
Indication
1
BAS* Adjust the bass.
1
TRE* Adjust the treble.
2
FAD* Adjust the front
and rear speaker
balance.
BAL Adjust the left
and right speaker
balance.
LOUD* 1 Boost low and high
frequencies to
produce a well-
balanced sound
at low volume level.
3
VOL* Adjust the volume.
1
* When you adjust the bass, treble, or loudness, the
adjustment you have made is stored for the
currently selected sound mode (C-EQ) including
"USER."
* 2
If you are using a two-speaker system, set the fader
level to "00."
3
* Normally the control dial works as the volume
control. So you do not have to select "VOL" to
adjust the volume level.
24
Each time you press the
button, the adjustable items
change as follows:
TRE FAD
(treble) (fader)
LOUD BAL
(loudness) (balance)
To do: Range
–06 (min.)
|
+06 (max.)
–06 (min.)
|
+06 (max.)
R06 (Rear only)
|
F06 (Front only)
L06 (Left only)
|
R06 (Right only)
LOUD ON
|
LOUD OFF
00 (min.)
|
50 (max.)
2
Adjust the setting.
Equalization pattern changes
as you adjust the bass or treble.
Ex. 1: When you adjust "TRE" (treble)
Ex. 2: When you turn on the loudness
3
Repeat steps 1 and 2 to adjust the
other items.
To reset each sound mode to the factory
settings, repeat the same procedure and
reassign the preset values listed in the table on
page 23.
To increase the level or
turn on the loudness
To decrease the level or
turn off the loudness