Finding The Beginning Of A Tune - JVC ks-lh60r Bedienungsanleitung

To play back tapes recorded with the
Dolby B NR*
1
Press M (MODE) to enter the functions
mode while listening to a tape.
"MODE" flashes on the upper part of the
display.
2
Press (Dolby B), while "MODE" is still
flashing on the display so that the
(Dolby B) indicator lights up.
"DOLBY B" also appears on the display for
several seconds.
To cancel the Dolby B NR, repeat steps 1
and 2 again so that the
goes off.
* Manufactured under license from Dolby
Laboratories.
"Dolby" and the double-D symbol are
trademarks of Dolby Laboratories.
Finding the beginning of a
tune
Multi Music Scan (MMS) allows you to
automatically start playback from the beginning
of a specified tune. You can specify up to 9 tunes
ahead of or before the current tune.
During playback
Specify the tune you want to locate (how
many tunes ahead of or before the
current tune).
20
(Dolby B) indicator
Press ¢
to locate a
tune ahead of the current
tune on the cassette.
Press 4
to locate a
tune before the current
tune on the cassette.
Ex.: When you locate three tunes ahead
of the current tune
Each time you press the buttons, the number
changes up to ±9.
When the beginning of the specified tune is
located, playback starts automatically.
Notes:
• While locating a specified tune:
– If the tape is rewound to its beginning, playback
starts from the beginning of that side.
– If the tape is fast-forwarded to the end, it is
reversed and played from the beginning of the
other side.
• In the following cases, the Multi Music Scan
function may not operate correctly:
– Tapes with tunes having long pianissimo
passages (very quiet parts) or non-recorded
portions between tunes.
– Tapes with short non-recorded sections.
– Tapes with high level of noise or humming
between tunes.
– Tapes with tunes recorded at low recording
levels.
– The Dolby NR setting does not match. For
example, if Dolby B NR is on and the tape was
recorded with no Dolby NR.