Z Memory Function; Z Soap Wash Programme; Z Soak Programme; Z Cool Down Function - Schulthess Spirit xTra 7015 Bedienungsanleitung

Memory function (ex factory OFF)
Select «Extended basic settings»!
If the memory function is switched on, the selected
temperature and spin additional functions are saved for
each programme. If the same programme is selected
again, the stored values are automatically used.
The values can then be altered.
Soap wash programme (ex factory OFF)
Select «Extended basic settings»!
When this programme is switched on, an extra rinse is
added.
Soak programme (ex factory OFF)
Select «Extended basic settings»!
When this programme is switched on:
soaking time of up to 12 hours.
X After the programme is selected, set the desired
soaking time by pressing the «Start time preselection»
button.
 The soaking time set or remaining is displayed until
the programme starts (1-12 hours).
X The soaking time starts when the start button is
pressed.
Notes:
X Add soaking detergent in section I of the detergent
drawer and your usual detergent in section II.
 The soaking programme must be reprogrammed for
each wash.
 Soaking can be interrupted and the wash programme
started by pressing the quick wash button.
 The current soaking time is stored in the event of a
power cut. The duration of the power cut is not taken
into account.
Cool down function (ex factory OFF)
Select «Extended basic settings»!
Detergent solution cooling: When the detergent solution
cooling function is switched on, boiling water is cooled
with cold water at the end of the washing process.
This helps to prevent damage to older drains.
This cooling always takes place in the easy care and Super-
finish pro grammes, irrespective of this setting. This helps
to prevent creases.
Loosening up at programme end (ex factory ON)
Select «Extended basic settings»!
When this function is selected, the laundry is tumbled
for 5 minutes at the end of the programme.
LCD Brightness (ex factory 220)
Select «Extended basic settings»!
The button can be used to alter the brightness of
the text on the display.
42
LCD Contrast (ex factory 26)
Select «Extended basic settings»!
The button can be used to alter the contrast on
the display.
Alarm volume (ex factory Volume 2)
Select «Extended basic settings»!
With the Alarm setting switched on, a signal sounds at
regular intervals at the end of the programme. The level
can be adjusted in 3 levels using the
Off
VOLUME 1
VOLUME 2
VOLUME 3
Standby function (ex factory OFF-MODE)
Select «Extended basic settings»!
"OFF"
The machine always remains switched on. The display
stays switched on (?).
"STANDBY-MODE"
Max. 4 minutes after the end of the programme the
machine switches off in energy saving mode. The display
will show «ZZZ».
"OFF-MODE"
Max. 4 minutes after the end of the programme the
machine automatically switches off. The display will be
dark.
"STANDBY + OFF-MODE"
Max. 4 minutes after the end of the programme the
machine switches off in energy saving mode. The display
will show «ZZZ».
Max. 10 minutes later the machine automatically switches
off. The display will be dark.
Note
If the display is dark, it can be activated by pressing
any button.
Optical interface (ex factory OFF)
Select «Extended basic settings»!
If the optical interface (SCS) is switched on, customer
services can communicate with the machine by PC.
Reduced mains power (ex factory OFF)
Select «Extended basic settings»!
If the connected load is reduced, the programme times
will be extended accordingly.
Off = 400V 2N ~ 4,0 kW / 10 AT
Off = 230V 1N ~ 4,0 kW / 16 AT
On = 230V 1N ~ 2,1 kW / 10 AT
button.