Ending The Programme With Rinsing Stop; Time; Language; Skincare Function - Schulthess Spirit eMotion 7020 Bedienungsanleitung

Time (the clock is not set ex factory)
+
The hours can be set using the
minutes using the
Language (ex factory DEUTSCH)
+ +
This setting is temporarily valid for the selected
programme and reverts back to the default language a
few minutes after completion of the programme.
(See «Extended basic settings / Default language»)
Extended basic settings
+
By pressing these three buttons at the same time, the
display shows the extended basic settings.
Repeatedly pressing the
possible settings.
Pressing the
changed.
Pressing the
settings.
Skincare function (ex factory OFF)
Select «Extended basic settings»!
If the skincare function is switched on, two extra rinses
are added to each wash programme. These additional
rinses can prevent skin allergies.
Child lock (ex factory OFF)
Select «Extended basic settings»!
The child lock is to prevent accidental starting, changing or
deletion of a programme by small children.
Operating the machine with the child lock switched on:
+
Hold the start button down and press the quick wash
button.
Rinsing stop (ex factory INDIVIDUAL)
Select «Extended basic settings»!
If this function is switched on, all easy care, fine wash or
shirt programmes automatically add a rinsing stop.
button and the
button.
+
button shows the
button allows the settings to be
button interrupts the display of the
42
Load metering (ex factory OFF)
That function is not relevant for this model.
Memory function (ex factory OFF)
Select «Extended basic settings»!
If the memory function is switched on, the selected
temperature and spin additional functions are saved for
each programme. If the same programme is selected
again, the stored values are automatically used.
The values can then be altered.
Soap wash programme (ex factory OFF)
Select «Extended basic settings»!
When this programme is switched on, an extra rinse is
added.
Soak programme (ex factory OFF)
Select «Extended basic settings»!
When this programme is switched on:
soaking time of up to 12 hours.
Set the desired soaking time by pressing the function
«Soaking» once or several times.
The soaking time starts when the start button is pressed.
Note:
Add soaking detergent in section I of the detergent
drawer and your usual detergent in section II.
The soaking programme must be reprogrammed for
each wash.
Soaking can be interrupted and the wash programme
started by pressing the Quick wash button.
The current soaking time is stored in the event of a
power cut. The duration of the power cut is not taken into
account.
Cool down function (ex factory OFF)
Select «Extended basic settings»!
Detergent solution cooling: When the detergent solution
cooling function is switched on, boiling water is cooled
with cold water at the end of the washing process.
This helps to prevent damage to older drains.
This cooling always takes place in the easy care
programme, irrespective of this setting. This helps to
prevent creases.
Loosening up at programme end (ex factory ON)
Select «Extended basic settings»!
When this function is selected, the laundry is tumbled for
5 minutes at the end of the programme.
Wash time reduction (ex factory ON)
Select «Extended basic settings»!
When this function is switched off, the boil, coloured
and easy care programmes are longer