Z Load Metering; Z Memory Function; Z Soap Wash Programme; Z Soak Programme - Schulthess Spirit topLine 8120 Bedienungsanleitung

Load metering (Option / ex factory ON)
Select «Extended basic settings»!
With the load metering switched on, the weight of the
loaded laundry is shown on the display.
To ensure that load metering functions properly, the
wash program must first be selected with the machine
door open and then the laundry must be loaded.
If the weight of the loaded laundry is smaller than half
the admissible wash weight, the wash time will be
shortened.
Please observe the hint on the display regarding the
reduction of the detergent quantity in case of smaller
laundry weights: The doses 1/2, 2/3, 1/1 (full) refer to
the quantities stated by the detergent manufacturer.
The load metering is not active for disinfection pro-
grammes.
Memory function (ex factory OFF)
Select «Extended basic settings»!
If the memory function is switched on, the selected
tem perature and spin additional functions are saved for
each programme. If the same programme is selected
again, the stored values are automatically used.
The values can then be altered.
With switched on memory button function, the special
programme last used is stored and appears again as
first on the display when next pressing the
Following this, the consecutive programmes can then be
selected through repeatedly pressing the button.
This way, a frequently used special programme can be
called up with only one press of the button.
When the function is switched off, the programme to
appear will always be the first programme in this pro-
gramme group.
The same applies to the profiClean programmes.
Soap wash programme (ex factory OFF)
Select «Extended basic settings»!
When this programme is switched on, an extra rinse is
added.
Soak programme (ex factory OFF)
Select «Extended basic settings»!
When this programme is switched on:
soaking time of up to 12 hours.
X After the programme is selected by pressing the time
preselect additional function button, set the desired
soaking time.
 The soaking time set or remaining is displayed until
the programme starts (1h-12h).
X The soaking time starts when the Start button is
pressed.
X Soaking can be interrupted and the wash programme
started by pressing the Quick Wash button.
54
Notes:
 Add soaking detergent directly to the drum.
(Detergent dosing see chapter «Detergents and care
addi tives / Detergent dosing»).
 The soaking programme must be reprogrammed for
each wash.
 The current soaking time is stored in the event of a
power cut. The duration of the power cut is not taken
into account.
Cool down function (ex factory OFF)
Select «Extended basic settings»!
Detergent solution cooling: When the detergent solution
cooling function is switched on, boiling water is cooled
with cold water at the end of the washing process.
This helps to prevent damage to older drains.
This cooling always takes place in the easy care and shirts
pro grammes, irrespective of this setting. This helps to
prevent creases.
Loosening up at programme end (ex factory ON)
Select «Extended basic settings»!
When this function is selected, the laundry is tumbled
for 5 minutes at the end of the programme.
button.
Wash time reduction (ex factory ON)
Select «Extended basic settings»!
When this function is switched off, the boil, coloureds
and easy care programmes are longer.
LCD Brightness (ex factory 220)
Select «Extended basic settings»!
The
the text on the display.
LCD Contrast (ex factory 26)
Select «Extended basic settings»!
The
the display.
Alarm volume (ex factory VOLUME 2)
Select «Extended basic settings»!
With the Alarm setting switched on, a signal sounds at
regular intervals at the end of the programme. The level
can be adjusted in 3 levels using the
Off
Volume 1
Volume 2
Volume 3
button can be used to alter the brightness of
button can be used to alter the contrast on
button.