Watching Tv; Turning On/Off The Power - Pioneer PDP-507XA Bedienungsanleitung

Watching TV

06
Watching TV
Unless you set up TV channels that you can watch under the
current conditions, you cannot tune in those channels. For the
procedure, see "Setting up TV channels automatically" on
page 27.

Turning on/off the power

NOTE
• When the Plasma Television is plugged into a power outlet,
it is placed into the standby mode; the STANDBY indicator
on its front panel should flash red. The Plasma Television
stays in the standby mode unless it is unplugged from the
power outlet.
To turn on the system, press POWER on the Plasma Television.
• The POWER ON indicator on the Plasma Television lights up
in blue.
To turn off the system, press a on the remote control unit or
STANDBY/ON on the Plasma Television.
• The Plasma Television is placed into the standby mode; the
STANDBY indicator lights up in red.
• You can then turn on the system again by pressing a or 0 to
9 on the remote control unit or STANDBY/ON on the Plasma
Television. If you press 0 on the remote control unit, images
come from the INPUT 1 source. If you press 1 to 9, TV images
display.
You can also press POWER on the Plasma Television to turn off
the system. However, you cannot then turn on the system
again by pressing the buttons on the remote control unit and
Plasma Television.
NOTE
• Before operating with the remote control unit, make sure to
select the TV mode using its SELECT button. See "Controlling
other equipment using the supplied remote control unit" on
page 48.
• When the system is placed into the standby mode, the main
power flow is cut and the system is no longer fully
operational. A minute flow of power feeds the system to
maintain operation readiness.
• If you are not going to use the Plasma Television for a long
period of time, be sure to remove the power cord from the
power outlet.
Plasma Television status indicators
The table below shows the operational status of the Plasma
Television. You can check the current status of the system with
the indicators on the Plasma Television.
Indicator Status
POWER ON STANDBY
For other than the above, see "Troubleshooting" on page 55.
20
En
The power cord of the Plasma Television has been disconnected. Or, the power cord of the Plasma Television has been
connected but the POWER button of the Plasma Television is off.
Power to the system is on.
The system is in the standby mode.
Plasma Television
(PDP-507XA)
POWER button
POWER ON indicator
POWER ON STANDBY
(PDP-427XA)
Viewed from
below of the
display (left)
1 2
INPUT
1
4
7
PC
INPUT 5
P
SELECT
TV STB
System Status
STANDBY indicator
POWER ON indicator
STANDBY indicator
ON STANDBY SLEEP
POWER button
3 4
2 3
5 6
8 9
INFO
0
DVD/
SOURCE
DVR VCR