Changing Channels - Pioneer PDP-507XA Bedienungsanleitung

Watching TV
Plasma Television
(right side view)
INPUT
CHANNEL +/–
1 2 3
4 5 6
7 8 9
INFO
0
PC
INPUT 5
P
DVD/
SELECT SOURCE
TV STB DVR VCR
Channel display
8
AAA
STEREO
10:00
STANDARD
FULL

Changing channels

NOTE
• Before operating with the remote control unit, make sure to
select the TV mode using its SELECT button. See "Controlling
other equipment using the supplied remote control unit" on
page 48.
Using P +/P – on the remote control unit
• Press P + to increase the channel number.
• Press P – to decrease the channel number.
When viewing Teletext information:
• Press P + to increase the page number.
• Press P – to decrease the page number.
• For Teletext, see "Using the Teletext Functions" on pages 53
and 54.
NOTE
• CHANNEL +/– on the Plasma Television operates the same
as P +/P –.
• P +/P – cannot pick up analogue channels that are set to
skip. For Channel Skip for analogue channels, see steps 13
and 14 under "Using Manual Adjust" (page 27).
• P +/P – cannot pick up analogue channels that are not
registered as favourites. For analogue favourite channel
registration, see steps 13 and 14 under "Using Manual
Adjust" (page 27).
Using 0 to 9 on the remote control unit
Select channels directly by pressing buttons 0 to 9.
EXAMPLE
• To select channel 2 (1-digit channel), press 2.
• To select channel 12 (2-digit channel), press 1 then 2.
When viewing Teletext information:
View a page directly which is 3-digit page number from 100 to
899 by pressing buttons 0 to 9. See page 54.
NOTE
• In the standby mode, when you press 0, the power turns on
and images come from the INPUT 1 source. Or, when you
press any button from 1 to 9, TV images display.
06
21
En