Installation Diagram Of Indoor And Outdoor Units; Installation Place - Toshiba MML-AP0074NH-E Installationshandbuch

Installation diagram of indoor and outdoor units

300 mm or more
Air fi lter
Batteries
Wireless remote control
Mounting screw

Installation place

• A place which provides the spaces around the indoor unit as shown in the diagram.
• A place where there are no obstacles near the air inlet and outlet.
• A place which allows easy installation of the piping to the outdoor unit.
• A place which allows the front panel to be opened.
• Direct sunlight to the indoor unit's wireless receiver should be avoided.
• The microprocessor in the indoor unit should not be too close to RF noise sources.
(For details, see the owner's manual.)
8-EN
Installation plate
300 mm or more
Shield pipe
Pan head wood screw
Remote control holder
Heat insulator
CAUTION
–8–
Installation Manual
Do not allow the drain hose to get slack.
Cut the piping
hole sloped
slightly.
Make sure to run the drain hose sloped
downward.
The auxiliary piping can be connected to
the left, rear left, rear right, right, bottom
right or bottom left.
Right
Rear right
Left
Bottom right Rear
left
Bottom left
Insulate the refrigerant pipes separately
with insulation, not together.
8 mm thick heat resisting
polyethylene foam
In case of right or left piping
Cut dot-line area
Toshiba 1112750201 (EN)