Installation Diagram Of Indoor And Outdoor Units; Optional Installation Parts - Toshiba RAS-10PKVSG-E Bedienungsanleitung

INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS

INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS
Battery
cover
"
!
Flat head
wood screw
The provided Remote Controller is a wireless
type, which also can be used as a wire.
Please see "How to Connect The Remote
Controller for Wired Operation", in case of
wired control is required.

Optional Installation Parts

Part
code
Refrigerant piping
Liquid side : Ø6.35 mm
Gas side
A
Pipe insulating material
B
(polyethylene foam, 6 mm thick)
Putty, PVC tapes
C
01_1118350131-EN.indd 6 01_1118350131-EN.indd 6
Downloaded from www.Manualslib.com
Flat head
wood screw
7
5
Batteries
3
Filter
7
Flat head
wood screw
4
Remote control
holder
2
Wireless remote control
Parts name
: Ø9.52 mm
(RAS-10, 13PKVSG-E)
: Ø12.70 mm
(RAS-16PKVSG-E)
manuals search engine
Hook
1 Installation
plate
Shield pipe
Refrigerant piping
must be protected from
physical damage.
Install a plastic cover or
equivalent.
Vinyl tape
Apply after carrying
out a drainage test.
Saddle
Extension drain hose
(Not available, provided
by installer)
Fixing bolt arrangement of outdoor unit
• Secure the outdoor unit with fi xing bolts and nuts if the unit is likely to be
exposed to a strong wind.
Q'ty
• Use Ø8 mm or Ø10 mm anchor bolts and nuts.
• If it is necessary to drain the defrost water, attach drain nipple # and cap
water proof $ to the bottom plate of the outdoor unit before installing it.
One
each
1
One
each
6
For the rear left and left piping
Wall
Insert the cushion between the indoor
unit and wall, and tilt the indoor unit for
better operation.
The auxiliary piping can be connected to
the left, rear left, rear right, right, bottom
right or bottom left.
Right
Rear
right
Bottom Rear
right left
Bottom left
Do not allow the drain hose to get slack.
Cut the piping
hole sloped
slightly.
Make sure to run the drain hose sloped
downward.
The fl are connection should be installed
outdoors.
Insulate the refrigerant pipes separately
with insulation, not together.
6 mm thick heat resisting
polyethylene foam
108 mm 125 mm
28 mm
Air inlet
Air outlet
90 mm
600 mm
Drain outlet
Left
2/10/2560 BE 10:06 AM 2/10/2560 BE 10:06 AM