Installation On The Wall - Toshiba MML-AP0074NH-E Installationshandbuch

Mounting directly on the fl oor
1) Fix the leg of indoor unit on the fl oor with 2 mounting
screws.
2) Fix the upper part of indoor unit on the wall with 4
mounting screws.
(Floor installation)
6 screw
(M4 x 25L)
NOTE
• In case the plinth is fi xed to the wall, please make
sure to cut out the slit on the left and right side of the
main part.

Installation on the wall

1) Fix the installation plate on the wall with 4 mounting
screws.
2) Hook the indoor unit on the installation plate.
3) Fix the upper part of indoor unit on the wall with 4
mounting screws.
(Wall installation)
4 screw
(M4 x 25L)
4 screw
(M4 x 25L)
Make sure to fi x it at a designated position with the
screws.
Failure may result the damage of piping by the turning
over of a set.
12-EN
Slit
Cut dot-line area
CAUTION
Concealed installation
1. Wall hole size
Wall hole size should be enough to keep the distance
with indoor unit as shown in the following fi gure.
(Front view)
300 or more
1300 or more
(700)
Floor
300 or more
Indoor unit
2. Installation using the supporting plate
• To install into the existing wall hole, if it is
impossible to keep 20-30 mm of depth, use the
supporting plate for securing the distance.
• Arrange the screw positions and supporting plate
as shown in the fi gure.
• Be sure to switch to wall burying mode.
(Rear screws potion)
670
: Screw holes
–12–
Installation Manual
(Unit : mm) (Side view)
100 or less
300 or more Floor
(Side view)
(Field supply)
(Unit : mm)
Toshiba 1112750201 (EN)