Cutting A Hole And Mounting Installation Plate - Toshiba MML-AP0074NH-E Installationshandbuch

5
CUTTING A HOLE AND MOUNTING INSTALLATION
PLATE
Cutting a hole
(Rear piping)
100 60
(Bottom piping)
100 70
1. After determining the pipe hole position, drill the pipe
hole (∅65 mm) at a slight downward slant to the
outdoor side.
NOTE
• When drilling a wall that contains a metal lath, wire
lath or metal plate, be sure to use a pipe hole brim
ring sold separately.
Mounting the installation plate and
screw position
10-EN
When installing the installation plate with a mounting
(Side piping)
screw, do not use the anchor bolt hole.
Otherwise the unit may fall down and result in personal
injury and property damage.
45
NO
GOOD
: Pipe hole (∅80 mm)
Failure to fi rmly install the unit may result in personal
injury and property damage if the unit falls.
• In case of block, brick, concrete or similar type walls,
make ∅5 mm holes in the wall.
• Insert clip anchors for appropriate mounting screws.
NOTE
• Secure four corners and lower parts of the installation
plate with 6 mounting screws to install it.
(Unit : mm)
Wall
Floor
–10–
CAUTION
OK NO
Anchor bolt
GOOD
∅5 mm hole
Mounting screw
4 mm x 25
Clip anchor
(local parts)
CAUTION
Toshiba 1112750201 (EN)
Installation Manual
Projection
15 mm or less
s