Sawing Off Larger Branches; Working Safely; Transport; Maintenance And Cleaning - FLORABEST FHEHS 900 A1 Originalbetriebsanleitung

♦ Sawing off larger branches
♦ When sawing larger branches (Ø 8–25 cm), fi rst make a relief cut
(see fi gure).
■ A relief cut also prevents peeling of the bark on the main trunk.
♦ Saw from the top to the bottom
B
B
2
A
Saw in sections.
Long or thick branches should be shortened before making the fi nal cut
(see fi gure).
c b a
C B A

Working safely

■ Keep the appliance, the cutting mechanism and the protective cover
for the blade in good condition to prevent injury.
■ If the appliance has been dropped, check for signifi cant damage or
defects.
■ Maintain the specifi ed angle 60°±10° to ensure safe working
(see fi gure).
max. 60°±10°
■ Do not use the appliance while standing on a ladder or with unsteady
footing.
■ Do not be tempted into making a poorly considered cut. You could
endanger yourself and others.
■ Children should be supervised to ensure that they do not play with the
appliance.
■ Change your working position regularly. Using the appliance for a long
time can lead to vibration-related circulation disorders of the hands.
You can extend the usage duration by means of appropriate gloves or
by taking regular breaks. Note that any personal predisposition to poor
blood circulation, low external temperatures or large prehensile forces
can reduce the usage period.
FHEHS 900 A1
.
A
1

Transport

A
■ Use the protective cases
■ Ensure that the appliance cannot switch on during transport (see
fi gure).

Maintenance and cleaning

WARNING! If the connecting cable needs to
be replaced, this must be carried out by the
manufacturer or his representative in order
to avoid safety hazards.
■ The motor unit must always be kept clean, dry and free from oil or
grease.
■ The pole pruner must be cleaned of sawdust at regular intervals.
♦ Use a soft, dry cloth to clean the housing.
♦ Remove the sprocket cover
♦ Remove the saw chain
♦ Keep the saw chain
and the oil supply.
♦ Check the hedge trimmer for loose screws on the cutter bar
tighten these if necessary.
♦ Remove stuck cuttings.
♦ Maintain the cutter bar

Storage

■ Always clean the appliance thoroughly before storing.
■ Store the appliance in its protective cases
of the reach of children.
■ Store the appliance horizontally or secured against falling.
■ Empty the oil tank .
■ Organic chain oil can resinify or leak through the vent hole in the oil
fi ller cap .
for transporting the appliance.
.
from the blade and clean the guide rail
sharp and check the tension; check the oil level
with an oil spray or an oil can.
in a dry place and out
GB
IE
.
and
9