Replacement Of The Connection Cable; Possibilities For Insertion - Electrolux EHS3920 Benutzerinformation

10 www.electrolux.com
• There is a risk of fire when the appli-
ance is in connection with an extension
cable, an adapter or a multiple connec-
tion. Make sure that the ground con-
nection agrees with the standards and
regulations.
• Do not let the power cable to heat up
to a temperature higher than 90° C.
Make sure that you connect the blue neu-
tral cable to the terminal with a letter "N"
on it. Connect the brown (or black) phase
cable to the terminal which has a letter
"L". Keep the phase cable connected at
all times.
8.3 Replacement of the
connection cable
To replace the connection cable use only
H05V2V2-F T90 type. Make sure that the
cable section is applicable to the voltage
and the working temperature. The yellow/
green earth wire must be approximately 2
cm. longer than the brown (or black)
phase wire.
8.4 Building in
min. 650 mm
If two or more 30 cm hobs are to be in-
stalled side by side into the same cut out,
an assembly kit is available at our Service
Centres. The kit contains a support side
bracket, supplementary seals and the in-
stallation instructions.
Put the seals supplied with the hob on the
edge of the cut out. Make sure that the
ends fit together without overlapping.
min. 100 mm
490 mm
270 mm
A) Supplied seal
B) Supplied brackets
CAUTION!
Install the appliance only on a
worktop with flat surface.

8.5 Possibilities for insertion

Kitchen unit with door
The panel installed below the hob must
be easy to remove and let an easy access
in case a technical assistance intervention
is necessary.
A
60 mm
B
A) Removable panel
B)
Space for connections
A
B
30 mm
min 20 mm
(max 150 mm)