Troubleshooting; Labels Supplied With The Accessories Bag - Electrolux EHS3920 Benutzerinformation

www.electrolux.com
8
The stainless steel can become tarnished
if it is too much heated. Refer to this you
must not cook with potstones, earthen-
ware pans or cast iron plates. Do not use
aluminium foil to prevent damage the top
during operation.
Stainless steel parts wash with water, and
then dry with a soft cloth.
Scratches or dark stains have no
effect on how the appliance oper-
ates.
Removing the dirt:
1.
Use the fine scouring powder or a
scouring pad to remove the dirt.

7. TROUBLESHOOTING

The appliance does not
operate.
The cooking zone does
not heat up.
The effectiveness of the
hob is not satisfactory.
If there is a fault, first try to find a solution
to the problem yourself. If you cannot find
a solution to the problem yourself, speak
your dealer or the local Service Force
Centre.
If you operated the appliance in-
correctly, or the installation was
not carried out by a registered en-
gineer, the visit from the customer
service technician or dealer may
not take place free of charge,
even during the warranty period.
Problem
2.
3.
4.
Possible cause and remedy
• Examine the fuse in the electrical system of the
house in the fuse box. If the fuses blow time after
time, speak to an authorised electrician.
• Make sure that the appliance is plugged in and the
electrical supply is switched on.
• Make sure that you turn the correct control knob.
• Examine the fuse in the electrical system of the
house in the fuse box. If the fuses blow time after
time, speak to an authorised electrician.
• Make sure that the hob is clean and dry.
• Make sure that the cookware is the correct size for
the cooking zone.
• Make sure that the cookware has a flat bottom.
• Make sure that the heat setting is correct for this
type of cooking.
These data are necessary to help you
quickly and correctly. These data are
available on the supplied rating plate.
• Model description .................
• Product number (PNC) .................
• Serial Number (S.N.) .................
Use the original spare parts only. They are
available at Service Force Centre and ap-
proved spare parts shops.
7.1 Labels supplied with the
accessories bag
Stick the adhesive labels as indicated be-
low:
Clean the appliance with a damp
cloth and some detergent.
Heat the hotplate to a low tempera-
ture and leave to dry.
To maintain the hotplates, rub in a lit-
tle sewing machine oil now and again
and then polish off with absorbent pa-
per.
For stainless steel edges of the
hob use cleaner for stainless steel.
The stainless steel edge of the
plate can be slightly discoloured
as a result of the thermal load.