Configuring The Network; Led Indicators; Software Update - Silvercrest SMRS 30 A1 Bedienungsanleitung

Configuring the network

The SMRS 30 A1 speaker is connected to the network via Wi-Fi. The built-in Wi-Fi antenna receives
the network router signals.
In order for the speaker to access the music files on the network, the network must meet the
following requirements:

DHCP must be enabled on the network router so the speaker can obtain an IP address
automatically.

UPnP media sharing has to be enabled on the router.
See the operating instructions for your router.

LED indicators

all LEDs off (while the power switch is
ON)
orange LED on
yellow LED on and blue LED on
blue LED flashes slowly
blue LED flashes 3 times fast, followed
by a short pause
blue LED on
green LED on
green and blue LEDs flashing fast
green and blue LEDs flashing slowly two
times

Software update

As the product is constantly being developed, it can sometimes become necessary to update the
software on your device. This will be notified with a corresponding notice in the app.
Please perform the software update according to the app instructions.
Please note that the update may take up to 15 minutes, depending
on the Internet connection and the number of devices to be updated.
Standby mode (network connection disabled)
Idle mode
Speaker is initialising
AP mode, waiting for network connection
WPS mode, waiting for WPS signal from router
Connected to the network
AUX mode
Wi-Fi connection fault
Maximum volume has been reached
SilverCrest SMRS 30 A1
English - 11