Connecting The Smoke-Machine; Operation; Unlock Program Mode; X 24 Channel Preset - EuroLite DMX SCENE SETTER 24 Bedienungsanleitung

Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120 resistor
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

5.4 Connecting the smoke-machine

You can connect analogue-controlled smoke-machines to the smoke-machine socket.
The pin occupation of the smoke-machine socket is as follows:
Between L – earthing = operating voltage smoke-machine
N = Switching contact for the pump

6. OPERATION

After you connected the device to the mains, the DMX Scene Setter is ready for use.

Unlock program mode

Before you can start programming you need to unlock the program mode.
Press and hold the Record-button.
Press the Flash-buttons 1, 6, 6, 8 in Preset A.
Release the Record-button.
The red LED above the Record-button is lit again and the program mode is unlocked.

2 x 24 channel Preset

With the Scene Setter you can adust two different scenes in Preset A and Preset B and fade from one to
another via the master-faders.
Press the Mode Select-button, until the A Double/Preset B-LED is lit.
Push Master A-fader to maximum.
Push channel-faders in Preset A to the desired setting.
Pull the Master B-fader to maximum.
Push channel-faders in Preset B to the desired setting.
Fade from Preset B to Preset A by pushing Master A-fader and Master B-fader.
In Double Preset-mode, the buttons over the master faders can be used as Flash-buttons.

Switch the dimmer display

The dimmer display can be switched from percent to the DMX-value:
Press and hold the Record-button.
Press the Insert-button and the display switched to the DMX-value (0-255).
In order to switch the display back to percent, repeat the procedure.

Memorize scenes

With the Scene Setter you can memorize up to 96 different scenes with 48 channels (Page 1 to Page 4).
Press the Mode Select-button, until the 1-48 Single/Preset Park-LED is lit.
Push the Master A-fader to maximum.
Push channel-faders to the desired setting.
Press the Record-button.
Press and hold the Record-button and press the desired Flash-button in Preset B.
The scene is now memorized on this fader.

Call up scenes

Press the Mode Select-button, until the Chase/Scenes-LED is lit.
Pull all channel-faders to minimum.
23/28 00020976.DOC, Version 1.5