Setup; Installation; Sound-Control; Connection With The Dimmerpacks - EuroLite DMX SCENE SETTER 24 Bedienungsanleitung

Rear panel:
1) DC IN socket
2) Power switch
3) MIDI THROUGH socket
4) MIDI OUT socket
5) MIDI IN socket
6) DMX output socket
7) DMX POLARITY selector
8) AUDIO IN socket
9) REMOTE socket
10) Smoke machine socket

5. SETUP

5.1 Installation

Install the device on a plane surface.
Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.

5.2 Sound-control

Via the sound-control, you can run the chasers sound-controlled.
Please note: The controller comes without pre-programmed chasers. These must first be programmed by
the user.
The sound-control works via built-in microphone or via the Line In-socket. Connect the sound-signal from the
mixer (e.g. Master 2) with the RCA-socket on the rear panel (input sensitivity 0.1 V - 1 V).
If a plug is connected with the Line In-socket, the internal microphone is switched off.

5.3 Connection with the dimmerpacks

DMX-512:
The wires must not come into contact with each other, otherwise
the fixtures will not work at all, or will not work properly.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Building a serial DMX-chain:
Connect the DMX-output of the SCENE SETTER with the DMX-input of the nearest dimmerpack. Always
connect one output with the input of the next fixture until all fixtures are connected.
22/28 00020976.DOC, Version 1.5