Sys-Ex Dump; Problem Chart - EuroLite DMX SCENE SETTER 24 Bedienungsanleitung

Select the desired MIDI-channel by pressing the respective Flash-button in Preset A.
Press and hold the Record-button.
Press the Rec Exit-button.
The MIDI-channel was memorized and you are in the normal mode again.

Sys-Ex Dump

With this function, you can transmit the memory content between two Scene Setters or to another Midi Sys-
Ex compatible Sequenzer or computer.
Please note: a received Sys-Ex Dump can delete all settings of a device. If you do not wish that a device
accidentally receives Sys-Ex data, switch it off or adjust another Midi-channel.
Connect the Midi Out-socket of the sending device with the Midi In-socket of the receiving one.
When sending or receiving Sys-Ex dump, the device ID is 55H.
The different functions of the individual notes are as follows:
Note Velocity
22-69 Program Master
70-93 Channel dimmer
94
95
96
97
98
99
100
101
102
Receive a Sys-Ex dump
Press and hold the Record-button.
Press the Flash-button 3 in Preset A three times.
Release the Record-button.
When the display will show In, the controller is ready for receiving the dump.
When receiving the dump, all other functions are switched off. As soon as the transmission is complete or
cancelled due to errors, the controller returns to normal operation mode.
Send a Sys-Ex dump
Press and hold the Record-button.
Press the Flash-button 4 in Preset A three times.
Release the Record-button.
When the display will show Out, the controller is ready for sending the dump.
When sending the dump, all other functions are switched off. As soon as the transmission is complete or
cancelled due to errors, the controller returns to normal operation mode.

7. PROBLEM CHART

PROBLEM
No power.
Display shows LOP.
Cannot memorize Scene.
Function
Turn on/off program 1-48
Turn on/off channel 1-24
Full On
Dark
Hold
Turn Audio chase on/off
Chaser/Scenes
Double Preset Mode
Single Preset Mode
Change step
Blackout
CAUSE
The power unit is not connected.
Operating volatage is too low.
Record-button forgotten.
Check the connection cable of the
power unit and any extension-cables.
Check the connection cable of the
power unit and any extension-cables.
Press the Record-button after setting
the channels.
27/28
REMEDY
00020976.DOC, Version 1.5