Cutting Angle; Cutting Speed; Cutting - Holzmann BS 712TOP Betriebsanleitung

14.5

Cutting angle

 Loosen nut (1)
 Set jaw to the desired angle
(scale 2) and retighten the nut.
 Vice jaw lock nut (3)
14.6

Cutting speed

 Loosen V-belt
 Adjust desired cutting speed
 Tighten V-belt
14.7

Cutting

 Full close the feed ON/OFF valve lever (2) and the feed rate control knob (1).
 Raise the saw arm as possible (If necessary, set the tension with spring adjusting knob 3)
 Clamp the workpiece
 Select cutting speed
 To start push SB1
 To start coolant use SA2
 Adjust the coolant rate with the coolant controller
 Open the feed ON/OFF valve lever (2)
 Slightly pull the saw arm down
 Open and adjust feed rate control knob (1) by slightly turning the valve counter-clockwise
to let saw arm descend with adequate speed and start cutting
 After cutting finished, machine can stopped automatically
 The cutting procedure can be interrupted by pushing SB2 and SB3
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
OPERATION
30
BS 712TOP